Перейти к основному содержанию

Возврат к шагу #31

Редактировать с помощью Sam Goldheart -

Правка одобрена автор Sam Goldheart

До
После
Без изменений

Шаг Линий

-[* black] As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.
-[* black] Carefully insert a guitar pick under the Lightning connector ribbon cable.
-[* black] Slide the guitar pick toward the logic board, but stop half an inch from the bend in the cable..
+[* icon_note] The Lightning connector cable is stuck to the case with some adhesive. To detach the adhesive you will be sliding an opening pick between the cable and the case. Be very careful not to cut the Lightning connector cable itself.
+[* black] Carefully insert a guitar pick under the ribbon cable near the Lighting connector housing.
+[* black] Slide the guitar pick toward the logic board, but stop half an inch from the bend in the cable.
[* black] Continuing farther along the ribbon cable risks cutting it.