Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #5

Редактировать с помощью Adam O'Camb -

Правка одобрена автор Adam O'Camb

До
После
Без изменений

Шаг Линий

[* black] Grind the location of the hole slightly until the surface feels a little rough.
[* black] Next, apply a thin coat of the rubber cement to an area that isaround the hole. The coat of cement should be about the same size ofas the patch to the location of the holepatch.
[* black] For best results wait until the rubber cement is trydry to the touch. 3 minutes or more. It does not matter it airing too longtouch—around three minutes.
[* black] Next, apply a thin coat of the rubber cement to an area that isaround the hole. The coat of cement should be about the same size ofas the patch to the location of the holepatch.
[* black] For best results wait until the rubber cement is trydry to the touch. 3 minutes or more. It does not matter it airing too longtouch—around three minutes.
[* black] Finally, peel off the back of the patch, place it over the area of rubber cement with the hole centered, and then apply pressure with thumb until rubber cement is dry.