Перейти к основному содержанию

Возврат к шагу #14

Редактировать с помощью Jeff Suovanen -

Правка одобрена автор Jeff Suovanen

До
После
Без изменений

Шаг Линий

-[* black] Wedge a plastic opening tool between the right side of the battery and the case.
-[* black] Pry the battery up to separate it from the adhesive securing it to the system board.
+[* black] Use scissors to cut one of your opening picks to about the width of the battery. Try not to leave any sharp corners.
+[* black] Insert the modified pick between the right side of the battery and the case.
+[* black] Use constant, steady pressure to ''slowly'' pry the battery up, separating it from the adhesive securing it to the system board.
+ [* icon_caution] Be careful not to deform or puncture the battery.
+ [* black] On the larger (42 mm) models, it's possible to [https://d3nevzfk7ii3be.cloudfront.net/igi/diYfGlClCsW1mXT2.full|accidentally pry at the system board|new_window=true] underneath the battery. Insert the pick only far enough to get underneath the battery, not the system board.
+ [* black] If needed, apply a little high concentration isopropyl alcohol (90% or greater) around and under the battery to help weaken the adhesive.
[* icon_caution] ***Do not*** attempt to remove the battery as it is still connected.

Изображение 1

Старая версия

Новая версия

Изображение 2

Старая версия

Новая версия

Изображение 3

Старая версия

Новая версия