Перейти к основному содержанию

Возврат к шагу #1

Редактировать с помощью Zacharias Merriam -

Правка одобрена автор Zacharias Merriam

До
После
Без изменений

Шаг Линий

[* icon_caution] Using a 1kohm resistor jig (wrap the wire of the resistor except the ends with electrical tape, use alligator clips, etc) connect the wires between the two RED CIRCLES shown. Maintain the connection for at least ten seconds.
-[* icon_note] The yellow circled hole should have its screw intact. It does not in this picture, but for proper discharging of the capacitor that screw needs to be inserted. It is a small, bronze/red screw.
+[* yellow] The yellow circled hole should have its screw intact. It does not in this picture, but for proper discharging of the capacitor that screw needs to be inserted. It is a small, bronze/red screw.
+[* red] Connect the wired resistor to these points in red.
+[* icon_note] For reference, consult the service manual. [https://docs.sony.com/release/mdsm/983465933_sm.pdf#page=24|Click to go to the service manual page on discharging the capacitor.]