Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #1

Редактировать с помощью weeowey weeowey -

Правка одобрена автор Carsten Frauenheim

До
После
Без изменений

Шаг Линий

[* icon_note] Remove any kapton tape over the screws, if necessary.
[* black] Remove the following 3 screws:
[* red] Two 3 mm Phillips screws near the dock connector.
[* orange] One 4 mm Phillips screw along the edge of the logic board.
[* icon_caution] During reassembly, make sure to put back any tape or plastic you remove. This will prevent any shorts between the logic board and the rear panel. If your tape is unusable, kapton tape can be purchased online.