Перейти к основному содержанию

Возврат к шагу #3

Редактировать с помощью Jeff Suovanen -

Правка одобрена автор Jeff Suovanen

Без изменений

Шаг Линий

-[* black] Open your container of adhesive remover.
-[* black] Fill the syringe included in your kit with a small amount (approximately 1-2 milliliters) of adhesive remover.
- [* icon_note] It's best to fill the syringe with no more than about 1-2 milliliters of adhesive remover at a time, so as to avoid accidentally applying too much.
- [* black] Refill your syringe as needed throughout the rest of this procedure.
+[* black] Pull off the black rubber stopper from your bottle of adhesive remover.
+[* icon_caution] Twist to loosen or remove the bottle cap before you cut the applicator tip.
+ [* icon_note] This unseals the bottle and allows the pressure to equalize before you cut the applicator tip. ***If you skip this step, the adhesive remover may spray out unexpectedly when the tip is cut.***
+[* black] Use scissors to cut off the sealed tip of the applicator.
+ [* icon_note] Cutting close to the narrow tip will give you better control so you can apply the adhesive remover in small amounts.
+[* icon_caution] Twist and close the bottle cap securely before you proceed further.

Изображение 1

Старая версия

Новая версия

Изображение 2

Старая версия

Новая версия

Изображение 3

Нет предыдущего изображения