Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Возврат к шагу #7

Редактировать с помощью John -

На одобрении

До
После
Без изменений

Шаг Линий

[* black] Use a heat gun to shrink the heat shrink over the joint.
[* black] If you are using electrical tape, start a small loop around the joint.
[* black] It's hard to fit the entire roll of tape through the space between the wires, so pull off some tape then tear it off the roll.
[* black] Wrap the entire joint in electrical tape. I always use a double layer, going up the joint one way, then back down to where I startedstarted.
[* black] Wrap the entire joint in electrical tape. I always use a double layer, going up the joint one way, then back down to where I startedstarted.