Перейти к основному содержанию

Возврат к шагу #6

Редактировать с помощью Dan -

На одобрении

До
После
Без изменений

Шаг Линий

-[* black] Disconnect the three antenna cables from the Airport card, and the black inverter cable from the logic board.
-[* icon_note] The inverter cable connector may be covered by a small piece of foam tape. Remove this cube before disconnecting the connector.
+[* black] Disconnect the three antenna cables from the Airport card.
+[* black] Disconnect the inverter cable from the socket by inserting the spudger between the right or left edge of the plug and the socket, and prying gently upward. The inverter plug lifts vertically off of the circuit board. Do not pull it in the direction of the connecting wires or you will tear the socket off.
[* icon_note] If you have a MacBook Core 2 Duo Santa Rosa/Penryn, there are only two antenna cables and the black inverter cable is in a different location.