Перейти к основному содержанию

Возврат к шагу #6

Редактировать с помощью Phil Bancroft -

На одобрении

До
После
Без изменений

Шаг Линий

[* black] Disconnect the three antenna cables from the Airport card. There may be a square foam piece over the logic board connector.
-[* icon_note] Disconnect the inverter cable from the socket by inserting the spudger between the right or left edge of the plug and the socket, and prying gently upward. The inverter plug lifts vertically off of the circuit board. Do not pull it in the direction of the connecting wires or you will tear the socket off.
+[* icon_note] Disconnect the inverter cable from the socket by inserting a spudger between the right or left edge of the plug and socket & prying gently upward. Be very careful. The top 1/2 of the connector/black cube is the plug- & the bottom 1/2 is the socket- fixed to the board. Find the join between plug and socket halfway up the black cube and lift up just the plug (top half) not the whole black cube- or you'll rip the socket & plug from the board.The inverter plug lifts vertically up off the socket on the circuit board. Don't pull in the direction of the connecting wires or you'll tear the socket off.
[* icon_note] If you have a MacBook Core 2 Duo Santa Rosa/Penryn, there are only two antenna cables and the black inverter cable is in a different location.