Перейти к основному содержанию

Возврат к шагу #3

Редактировать с помощью Evan Noronha -

Правка одобрена автор Evan Noronha

До
После
Без изменений

Шаг Линий

[* black] Pull up on the suction cup with firm, constant pressure to create a slight gap between the front panel and rear case.
+ [* icon_note] Take your time and apply firm, constant force. The display assembly is a much tighter fit than most devices and is held down with adhesive.
[* icon_caution] Pulling too hard may damage the display assembly. Apply just enough pressure to create a small gap between the display assembly and the rear case.