Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #4

Редактировать с помощью Adam Olzick -

Правка одобрена автор Adam Olzick

До
После
Без изменений

Шаг Линий

[* black] Remove the following six screws securing the logic board assembly to the upper case.
[* red] One 3.8 mm T5 Torx screw
[* orange] Two 5.7 mm T5 Torx screws
[* yellow] One 5.6 mm T5 Torx screw (this one is silver and has a taller head than the others)
[* green] One 2.6 mm T5 Torx screw
[* light_blue] One 3.2 mm T5 Torx screw
[* icon_reminder] On reassembly, start all six screws but do not tighten any of them. Move the logic board around until all of the screws are centered in their holes,holes and the ports are lined up with their openings in the side of the upper case. Then tighten all of the screws.
[* icon_reminder] On reassembly, start all six screws but do not tighten any of them. Move the logic board around until all of the screws are centered in their holes,holes and the ports are lined up with their openings in the side of the upper case. Then tighten all of the screws.