Перейти к основному содержанию

Возврат к шагу #10

Редактировать с помощью pollytintop -

На одобрении

До
После
Без изменений

Шаг Линий

+[* black] the metal shield covering all the tiny chips within the iphone.
+ [* black] to remove this shield you will need a flat head screwdriver
+ [* black] insert screwdriver parallel to tab just above tab on motherboard and twist gently about 45 degrees, move along row of tabs from near connector 1 to join of metal cover.
+ [* black] move to opposite side of metal shield near connector 5 and 6 and repeat above step with screwdriver
+ [* black] slip screwdriver under cover, angling upwards toward metal shield so that you are applying no pressure to internal components, and insert screwdriver along join of metal shield.
+ [* black] move to other half of shield and insert screwdriver to tabs along side near connector 4. it is not advisable to lever tabs surrounding connector 4 as you may damage tiny fuses accidently.
+ [* black] lever tabs along bottom edge closest to where dock connector would sit.
+ [* black] finally insert screwdriver up and under shield angling upwards again and use screwdriver to lever up join using slight turns as you move along the join. the metal shield should then be able to be lift free.

Изображение 1

Нет предыдущего изображения

Добавлено

Изображение 2

Нет предыдущего изображения

Добавлено