Перейти к основному содержанию

Возврат к шагу #4

Редактировать с помощью Andrew Bookholt -

На одобрении

До
После
Без изменений

Шаг Линий

[* icon_note] In the following steps, you will be working on your new upper case.
-[* red] Use a T6 Torx screwdriver to loosely install the 1.2 mm set screw included with your new upper case into its tapped hole near the middle of the trackpad opening on your new upper case.
+[* red] Use a T6 Torx screwdriver to loosely install the 1.1 mm set screw included with your new upper case into its tapped hole near the middle of the trackpad opening on your new upper case.
[* icon_caution] Only tighten it about one turn for now.