Перейти к основному содержанию

Возврат к шагу #6

Редактировать с помощью Andrew Bookholt -

На одобрении

До
После
Без изменений

Шаг Линий

-[* red] Insert a mm Phillips screw into each of the outer holes drilled into the trackpad (two screws total).
+[* red] Insert a 1.2 mm Phillips screw into each of the outer holes drilled into the trackpad (two screws total).
[* icon_caution] You'll install the rest in a bit.
[* icon_note] When you tighten the two screws, make them tight and then back them out about a quarter turn to aid in aligning your trackpad during the next few steps.