Перейти к основному содержанию

Возврат к шагу #9

Редактировать с помощью Andrew Bookholt -

На одобрении

До
После
Без изменений

Шаг Линий

-[* black] Insert wisdom here.
+[* black] Tighten the outer two screws along the inner edge of the trackpad and check the alignment of it on the outer side of the upper case.
+[* black] If its alignment looks good, install the rest of the Phillips screws along the inner edge of the trackpad.
+[* black] Before reassembling your machine, verify that the set screw is still installed in a position so the mouse will click correctly.