Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #3

Редактировать с помощью Jeff Suovanen -

Правка одобрена автор Jeff Suovanen

До
После
Без изменений

Шаг Линий

[* icon_caution] Try not to wrinkle the strips during this procedure—they will become very difficult to deal with and will not straighten out again.
[* black] Pull one of the adhesive strips straight out, towards the bottom edge of the rear caseiPhone.
[* black] As you're pulling, keepFor best results, pull the strip as flat and wide as possible, applying constant, firm pressureat a 60º angle or less.
[* icon_note] The strip will stretch to many times it'sits original length. As you're pulling it may be helpfulContinue to wrap it around your fingerpull steadily, re-grabbing the strip closer to the iPhone if necessary.
[* black] Continue pulling until itthe strip is fully removed.
[* icon_caution] If the battery adhesive tabs break off at any point during the removal process, use your fingers or blunt tweezers to retrieve the remaining length of adhesive, and continue pulling.
[* black] If one of the adhesive strips breaks under the battery during this procedure, and cannot be retrieved, remove the remaining strip, and then skip to [guide|62577|Step 48|stepid=131730].
[* icon_caution] Try not to wrinkle the strips during this procedure—they will become very difficult to deal with and will not straighten out again.
[* black] Pull one of the adhesive strips straight out, towards the bottom edge of the rear caseiPhone.
[* black] As you're pulling, keepFor best results, pull the strip as flat and wide as possible, applying constant, firm pressureat a 60º angle or less.
[* icon_note] The strip will stretch to many times it'sits original length. As you're pulling it may be helpfulContinue to wrap it around your fingerpull steadily, re-grabbing the strip closer to the iPhone if necessary.
[* black] Continue pulling until itthe strip is fully removed.
[* icon_caution] If the battery adhesive tabs break off at any point during the removal process, use your fingers or blunt tweezers to retrieve the remaining length of adhesive, and continue pulling.
[* black] If one of the adhesive strips breaks under the battery during this procedure, and cannot be retrieved, remove the remaining strip, and then skip to [guide|62577|Step 48|stepid=131730].