Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #7

Редактировать с помощью Ziv Gillat -

На одобрении

До
После
Без изменений

Шаг Линий

[* black] Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape as necessary.
[* icon_note] Note: It is possible to replace the hard drivefan without disconnecting the keyboard from the chassis, but it will need to be held upright to keep it out of the way, while still allowing you both hands to work on the drive removal. Be careful when removing the keyboard-trackpad ribbon cable to ensure that the rear of the upper case is disengaged from the area near the hinge. It is easy to accidentally bend the screw receivers on either side of the keyboard.
[* icon_note] Note: It is possible to replace the hard drivefan without disconnecting the keyboard from the chassis, but it will need to be held upright to keep it out of the way, while still allowing you both hands to work on the drive removal. Be careful when removing the keyboard-trackpad ribbon cable to ensure that the rear of the upper case is disengaged from the area near the hinge. It is easy to accidentally bend the screw receivers on either side of the keyboard.
[* black] Remove the upper case.