Перейти к основному содержанию

Возврат к шагу #2

Редактировать с помощью Richdave -

На одобрении

До
После
Без изменений

Шаг Линий

-[* black] Remove the faulty EM10 filter. Using tweezers or pliers and a soldering iron works best.
+[* black] Remove the faulty EM10 filter. Use a soldering iron to melt the solder and gently lift off the filter with tweezers or pliers being careful not to pull the copper tracks off the motherboard.
[* icon_note] A replacement EM10 filter is available [http://www.logictoyz.com/nintendo-ds/nintendo-ds-lite-spare-parts/ds-lite-em10-filters-.html|HERE] (as at 01/01/12) no doubt other suppliers exist
[* black] Solder new EM10 filter into place, ensuring correct orientation. If required, check the new filter with a multimeter to confirm before installing.
-[* red] Alternate method - Bridge the solder pads that correspond with each set of pads - yellow to yellow and cyan to cyan
+[* icon_caution] Alternate method - Bridge the solder pads that correspond with each set of pads - yellow to yellow and cyan to cyan
+[* icon_note] Bypassing the EM10 filter may affect the system performance and is not recommended

Изображение 1

Старая версия

Новая версия

Изображение 2

Старая версия

Новая версия