Перейти к основному содержанию

Возврат к шагу #3

Редактировать с помощью Phillip Takahashi -

На одобрении

До
После
Без изменений

Шаг Линий

-[* black] If present, use a plastic opening tool to help remove the piece of tape covering the end of the dock connector cable.
+[* black] Use a plastic opening tool to help remove the piece of tape covering the end of the dock connector cable.
[* black] Use the edge of a plastic opening tool to carefully pry the dock connector cable's connector up from its socket on the logic board.
[* black] Peel the dock connector ribbon cable off the rear panel.