Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #6

Редактировать с помощью Kalynn Copeharve -

Правка одобрена автор Kalynn Copeharve

До
После
Без изменений

Шаг Линий

[* black] Apply heat to the heatshrink by moving the hair dryer back and forth over the entire length of the heatshrink until the adhesive is fully stuck to the wireheatshrink.
[* black] IfWhile heating, keep the size of heatshrink you are using ishairy dryer in motion. Applying heat for too largelong in one location will result in overheating. Overheating may further damage the frayed or exposed wire underneath, and it is not sticking tocan even melt the wire immediately, continue to heat the heatshrink until it sticjs to the entire wire, or consider getting a smaller size of heatshrinkshrink itself.
[* black] Apply heat to the heatshrink by moving the hair dryer back and forth over the entire length of the heatshrink until the adhesive is fully stuck to the wireheatshrink.
[* black] IfWhile heating, keep the size of heatshrink you are using ishairy dryer in motion. Applying heat for too largelong in one location will result in overheating. Overheating may further damage the frayed or exposed wire underneath, and it is not sticking tocan even melt the wire immediately, continue to heat the heatshrink until it sticjs to the entire wire, or consider getting a smaller size of heatshrinkshrink itself.