Перейти к основному содержанию

Changes to Step #19

Edit by theonw

На одобрении

Удален
Добавлено
Без изменений

Шаг Линий

[* black] Connect both the SATA data and SATA power connectors to their respective sockets on the SSD.
[* black] Peel the backing off of the double sided tape.
[* black] Carefully set the SSD into the iMac optical bay as close to the lower left corner as possible.
[* icon_caution] Do not to repeatedly stick and un-stick the tape, as the adhesive will become weaker.
[* black] Once you are happy with the SSD's placement, firmly press down along its edges to ensure full adhesion.
[* icon_note] When re-installing the optical drive, the SATA cable will be sandwiched between the foam padding and the optical drive.
[* black] Now reverse the steps to put it all back together. Once completed, power on booting from your install disk and select "Restore using a Time Machine Backup".
[* black] After about 3 minutes the CPU fan will rev to full power, This is because Apple uses its own hard drive firmware for temp readings. Go to http://www.hddfancontrol.com and download the software if you wish to reduce the speed to normal.