Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Возврат к шагу #3

Редактировать с помощью Dominik Schnabelrauch -

Правка одобрена автор Dominik Schnabelrauch

До
После
Без изменений

Шаг Линий

[title] bar montage
[* black] insert barGo on with positioning the handlebar centered in the stem clamp and put the faceplate back on.
[* black] put frontRetighten the bolts of stern backthe faceplate while the bar is in a adequate position with slightly pointing down brake levers, until they hold the bar.
[* black] Now tighten screwsthe bolts in a over cross pattern, starting with upper left going to lower right, then upper right going to lower left. The torque wrench value for this should be around '''8Nm'''.
[* icon_caution] Make sure the upper and lower clamping slots between faceplate and stem body are parallel and identical width.
[* black] insert barGo on with positioning the handlebar centered in the stem clamp and put the faceplate back on.
[* black] put frontRetighten the bolts of stern backthe faceplate while the bar is in a adequate position with slightly pointing down brake levers, until they hold the bar.
[* black] Now tighten screwsthe bolts in a over cross pattern, starting with upper left going to lower right, then upper right going to lower left. The torque wrench value for this should be around '''8Nm'''.
[* icon_caution] Make sure the upper and lower clamping slots between faceplate and stem body are parallel and identical width.