Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Возврат к шагу #7

Редактировать с помощью Tobias Isakeit -

Правка одобрена автор Tobias Isakeit

До
После
Без изменений

Шаг Линий

[* black] BringSlide the front wheel intoaxle in from the right position betweenhand side with the dropouts and slide the axle with open quick-release lever from the left side through the drop-out and the hubopened.
[* black] As soon as the axle thread engages with the thread of the rightleft fork leg, close it by turning clockwise. Tighten the axleNow go back a littlethird of a turn and then release it by about a thirdclose the lever.
[* icon_note] The best closing position is in nearly upright position in front
of a turn.
[* black]
the lower fork leg. If the lever cannot be closed completely, re-opencompletely in the correct position (or is too loose), unscrew it, take it out and turnre-align the axle a little anti clockwise.
[* icon_caution
by pushing down the lever part and turning it against the shaft.
[* black
] In its end position the quick-release lever should be tight so that it can no longer be turned. The best closing position is in nearly upright position in front of the lower fork leg.
[* black] BringSlide the front wheel intoaxle in from the right position betweenhand side with the dropouts and slide the axle with open quick-release lever from the left side through the drop-out and the hubopened.
[* black] As soon as the axle thread engages with the thread of the rightleft fork leg, close it by turning clockwise. Tighten the axleNow go back a littlethird of a turn and then release it by about a thirdclose the lever.
[* icon_note] The best closing position is in nearly upright position in front
of a turn.
[* black]
the lower fork leg. If the lever cannot be closed completely, re-opencompletely in the correct position (or is too loose), unscrew it, take it out and turnre-align the axle a little anti clockwise.
[* icon_caution
by pushing down the lever part and turning it against the shaft.
[* black
] In its end position the quick-release lever should be tight so that it can no longer be turned. The best closing position is in nearly upright position in front of the lower fork leg.

Видео

Видео добавлено

Изображение 1

Удален

Изображение 2

Удален