Перейти к основному содержанию

Возврат к шагу #5

Редактировать с помощью Walter Galan -

На одобрении

До
После
Без изменений

Шаг Линий

-[* red] Remove the Phillips set screw from its tapped hole near the middle of the trackpad opening on the upper case.
+[* red] Remove the 1.4 mm Phillips set screw from its tapped hole near the front edge of the upper case.
+[* icon_reminder] During reassembly, do not over-tighten the set screw, as the button will cease to click at a certain point. Adjust the set screw until the movable side of the trackpad has minimal play.