Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #7

Редактировать с помощью Ron Davis -

Правка одобрена автор Ron Davis

До
После
Без изменений

Шаг Линий

[* orange] Undo hard driveFlip up the retaining flaps on each end of the I/O board ribbon by lifting black clips upwardcable ZIF connector.
[* black] Carefully pull the the I/O board ribbon cable from its sockets.
[* red] UndoRemove the two 4.6 mm screws (4.6 mm) holding the hard drive in place
[* black] There may be only one screw of these screws, the one at bottom right. The upper position screw may already have been removed (The 4th red circle from the left in step 4)place.
[* orange] Undo hard driveFlip up the retaining flaps on each end of the I/O board ribbon by lifting black clips upwardcable ZIF connector.
[* black] Carefully pull the the I/O board ribbon cable from its sockets.
[* red] UndoRemove the two 4.6 mm screws (4.6 mm) holding the hard drive in place
[* black] There may be only one screw of these screws, the one at bottom right. The upper position screw may already have been removed (The 4th red circle from the left in step 4)place.