Перейти к основному содержанию

Изменения в этом шаге

Редактировать с помощью Jake Devincenzi -

На одобрении

До
После
Без изменений

Шаг Линий

-[* black] Set the new hard drive into the open area where the plastic positioner was.
- [* icon_note] Make sure that the connectors on the hard drive are facing down, as shown, otherwise you will not be able to install the drive.
-[* black] While firmly holding the enclosure in place with one hand, use your other hard to press the hard drive over the enclosure connectors.
-[* black] Once the hard drive is snug, reinsert the plastic positioner, while holding the hard drive against the bottom of the enclosure.
+[* red] Make sure that the hard drive connectors are facing down before placing it into the enclosure.
+[* black] Gently place the hard drive into the enclosure's hard drive slot.
+[* black] While firmly holding the enclosure in place with one hand, use your other hard to press the hard drive into the enclosure connectors.

Изображение 1

Старая версия

Новая версия

Изображение 2

Старая версия

Новая версия

Изображение 3

Старая версия

Новая версия