Перейти к основному содержанию

Возврат к шагу #3

Редактировать с помощью Ben Eisenman -

На одобрении

До
После
Без изменений

Шаг Линий

[* black]icon_note] If you have the original version of the MacBook Air (A1237), refer to picture 1. Remove the following screws securing the heat sink to the logic board:
[* black]icon_note] If you have the original version of the MacBook Air (A1237), refer to picture 1. Remove the following screws securing the heat sink to the logic board:
[* red] One 5.9 mm Phillips screw.
[* orange] Two 1.9 mm Phillips screws.
[* [* yellow] Remove theOne 1.9 mm Phillips screw securingscrew.
[* icon_note] If you have
the processor clampA1304 version of MacBook Air, refer to picture 2. Remove the following screws securing the heat sinksink to the logic board:
[* red] One 5.0 mm Phillips screw
[* orange] Five 1.9 mm Philips screws.
[* yellow] One 2.5 mm Phillips screw
.
[* [* yellow] Remove theOne 1.9 mm Phillips screw securingscrew.
[* icon_note] If you have
the processor clampA1304 version of MacBook Air, refer to picture 2. Remove the following screws securing the heat sinksink to the logic board:
[* red] One 5.0 mm Phillips screw
[* orange] Five 1.9 mm Philips screws.
[* yellow] One 2.5 mm Phillips screw
.

Изображение 1

Старая версия

Новая версия

Изображение 2

Нет предыдущего изображения

Добавлено