Перейти к основному содержанию

Возврат к шагу #3

Редактировать с помощью Tobias Isakeit -

Правка одобрена автор Tobias Isakeit

До
После
Без изменений

Шаг Линий

-[* black] Adjust the braking lever to around 45° and remove the bleeding screw.
-[* black] Fill up the bleeding syringe to the half and install it to the braking lever. *** - ONLY USE DOT 5.1 - Remove all air bubbles from the syringe to prevent, that they come into the system during the bleeding procedure. ***
-[* black] Install the hose on the bleeding nipple, then open the nipple around 1/2 turns. ***Please be careful also and watch out for air bubbles into the syringe.***
+[* black] Adjust the braking lever to a 45° angle and remove the bleeding screw.
+[* black] Fill up half the bleeding syringe. Make sure there are no bubbles by flicking it so they don't get into the system during the bleeding procedure.
+[* black] Mount the syringe to the braking lever.
+ [* icon_note] Only use DOT 5.1 brake fluid.
+[* black] On the caliper side install the hose on the bleeding nipple, then open the nipple 1/2 turn.
+ [* icon_note] Again, watch out for air bubbles in the syringe. You don't want them.