Перейти к основному содержанию

Возврат к шагу #8

Редактировать с помощью Taylor Dixon -

Правка одобрена автор Taylor Dixon

До
После
Без изменений

Шаг Линий

-[* black] Using a spudger, disconnect the black and white signal wires located at the bottom of the daughterboard.
+[* black] Use a spudger to pry up the black and white [guide|25629|coaxial cables|stepid=64972|new_window=true] attached to underside of the daughterboard.
+ [* icon_caution] Coaxial cable connectors and sockets are fragile. To avoid damaging the connectors, be sure to gently pry them straight off of the board.
+[* icon_reminder] When reconnecting these cables, lay the daughterboard upside down on the battery and use tweezers to carefully position each connector over its socket on the board, then press it straight down until it snaps into place.
[* black] Remove the daughterboard from the device.

Изображение 2

Старая версия

Новая версия

Изображение 3

Старая версия

Новая версия