Перейти к основному содержанию

Возврат к шагу #2

Редактировать с помощью Adam O'Camb -

Правка одобрена автор Adam O'Camb

До
После
Без изменений

Шаг Линий

[* black] In the following steps you will be cutting through the adhesive around the edge of the rear glass panel.
[* black] The adhesive on the rear case is laid out as seen in the first image.
[* black] The prying pattern as seen from the outside of the phone is as follows:
[* black] Thick portions of adhesive
[* black] Thin areas of adhesive
[* black] Avoid prying here, to protect the fingerprint sensor.