Перейти к основному содержанию

Изменения в этом шаге

Отредактированно Adam O'Camb -

Правка одобрена автор Adam O'Camb

До
После
Без изменений

Шаг Линий

+[* icon_caution] Before you start placing strips, remove all of the old adhesive around the perimeter of the rear enclosure.
+ [* black] If you are re-using your existing display, you must also remove the old adhesive from the back of the display.
+[* black] Use a pair of tweezers to grasp and peel up the edge of each adhesive strip.
+ [* icon_reminder] Repeat this process as necessary to remove all of the old adhesive.
+ [* icon_note] If necessary, use a spudger to scrape up the remaining adhesive, then peel with your fingers.

Изображение 1

Нет предыдущего изображения

Добавлено

Изображение 2

Нет предыдущего изображения

Добавлено