Перейти к основному содержанию

Изменения в этом шаге

Отредактированно Adam O'Camb -

Правка одобрена автор Adam O'Camb

До
После
Без изменений

Шаг Линий

+[* icon_note] ''At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips.''
+ [* black] ''If you've already verified that your iMac is working correctly and are ready to seal it up, ***skip to Step 17***.''
+[* black] Insert the display power cable into its socket on the logic board.

Изображение 1

Нет предыдущего изображения

Добавлено

Изображение 2

Нет предыдущего изображения

Добавлено