Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #7

Редактировать с помощью Jake Devincenzi -

На одобрении

До
После
Без изменений

Шаг Линий

[* red] Remove the outer four 5.3 mm T8 Torx screws holding the hinges in place.
[* icon_note] Do not remove the two innerinnermost screws just yet.
[* icon_note] Do not remove the two innerinnermost screws just yet.
[* black] Open the device between 90 and 100 degrees, then rest it on its side.
[* red] While supporting both halves of the device with one hand, unscrew the upper 5.3 mm T8 Torx screw.
[* red] Repeat the same process for the identical bottom screw.
[* icon_caution] Be sure to hold the display and upper case together with one hand. Failure to do so may cause the freed display/upper case to fall, potentially damaging each component.