Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #2

Редактировать с помощью Christopher Hill -

Правка отклонена автор Jake Devincenzi

До
После
Без изменений

Шаг Линий

[* black] Disconnect the microphone cable connector, removing tape as necessary.
[* icon_reminder] For the front bezel to sit properly, be sure to tuck the microphone cable and connector into the void next to the camera board.
[* black] If you are not removing the bezel, but just trying to access the internals, then you can leave the microphone cable attached and just lift the bottom of the bezel up and over the computer so that it rests face down. There is enough microphone cable to allow them to remain connected if you have the room.