Перейти к основному содержанию
Помощь
Редактирование шага 5 —

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Тип шага:

Перетащите чтобы изменить порядок

In the following steps, you will use a heat gun to soften the adhesive securing the outer silver border around the underside of the front panel to the display.

With the heat gun set to low, start by heating the metal bezel surrounding the LCD.

When using the heat gun, the goal is to soften a layer of adhesive holding the bezel to the display assembly. Be very careful not to overheat the LCD, as it could cause permanent damage.

Ваш вклад лицензируется под свободной лицензией Creative Commons.