Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Редактирование шага 2 —

Тип шага:

Перетащите чтобы изменить порядок

With the tubes and caps in place now is a good time check for leaks.

If your valves have been removed begin putting them into place.

Make sure that threads are line up and do not apply too much for to the valves.

As mentioned in the disassemble using the proper valve removal tools is always best but with care you can use standard tools as shown.

Once everything in place you can gas up the magazine. I recommend using a green gas can that is not at full pressure to save on gas if it turns out that there still is a leak. If the lower pressure gas does not leak try filling the magazine with a full can of gas to see if it can handle the higher pressure.

If your trying find where a leak is coming from you can use the silicone spray on hole magazine and look for the bubbles.

Ваш вклад лицензируется под свободной лицензией Creative Commons.