Перейти к основному содержанию
Помощь
Редактирование шага 28 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Тип шага:

Перетащите чтобы изменить порядок

When reinstalling the logic board assembly:

Check the alignment of the rubber vibration dampers, and adjust them as needed.

Feed the antenna cable bundle through the gap between the logic board and heat sink, and make sure it lines up correctly as you lower the board into place.

Verify that no cables get trapped under the board as you install it. Check each marked location carefully.

Ваш вклад лицензируется под свободной лицензией Creative Commons.