Skip to main content
Помощь
Редактирование шага 8 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 5 guides that include this step.

Тип шага:

Перетащите чтобы изменить порядок

Use the flat end of a spudger (or an opening tool) to very carefully pry the touch screen cable connector up off the upper logic board.

The touch screen ribbon cable is extremely fragile! Be very gentle in disconnecting this cable to prevent tearing the ribbon cable.

Now that the front panel is out, check it for damage. If the plastic surround is not flush with the front face of the glass panel, gently peel it off and stick it down.

Be careful not to scratch the front panel on the underside of the black portions, as the scratches will be visible once the device is reassembled.

Be sure to clean both the face of the display and the inner surface of the front panel, as any dust or fingerprints will be trapped inside the Touch once it is fully reassembled.

Ваш вклад лицензируется под свободной лицензией Creative Commons.