Перейти к основному содержанию
Редактирование шага 2 —

Тип шага:

Перетащите чтобы изменить порядок

Remove the faulty EM10 filter. Use a soldering iron to melt the solder and gently lift off the filter with tweezers or pliers, being careful not to pull the copper tracks off the motherboard.

A replacement EM10 filter is available HERE (as at 01/01/12) no doubt other suppliers exist

Solder new EM10 filter into place, ensuring correct orientation. If required, check the new filter with a multimeter to confirm before installing.

Alternate method - Bridge the solder pads that correspond with each set of pads - yellow to yellow and cyan to cyan

Bypassing the EM10 filter may affect the system performance and is not recommended

Ваш вклад лицензируется под свободной лицензией Creative Commons.