Введение

Remove bottom housing to reveal the inside of the iMac.

Запчасти

Никакие детали не требуются.

Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.
  • Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.

Добавить комментарий

Loosen the four Phillips #0 screws.
  • Loosen the four Phillips #0 screws.

Добавить комментарий

  • Carefully remove the base access panel.

Добавить комментарий

  • Remove the four 25mm T-15 screws.

Добавить комментарий

  • Open the housing plate.

  • Be gentle with the wires still connected to the logic board so as not to ruin the cables.

  • A fixed plug connector between the logic board and upper unit will cause some resistance. Pull gently but firmly.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

6 участников успешно повторили данное руководство.

Justin

Участник с: 05.10.2011

235 Репутация

Автор 3 руководств

Команда

Cal Poly, Team 21-22, Maness Fall 2011 Member of Cal Poly, Team 21-22, Maness Fall 2011

CPSU-MANESS-F11S21G22

4 членов

Автор 13 руководств

Один комментарий

If you do this - don't you still need to apply a fresh coat of thermal paste to the exposed ends of the two heat-sink posts (that separate when you open a G4 flatpanel this far) - my understanding was that the machine would overheat and you'd be left with didley squat!!

Gregg :O)

amicuset - Ответить

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 7

За всё время: 1,591