Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Запчасти

Детали не указаны.

  1. Use the tip of a spudger to disconnect the fan cable's connector from its socket on the logic board. Use the tip of a spudger to disconnect the fan cable's connector from its socket on the logic board. Use the tip of a spudger to disconnect the fan cable's connector from its socket on the logic board.
    • Use the tip of a spudger to disconnect the fan cable's connector from its socket on the logic board.

  2. Peel the black tape connecting the fan to the exhaust duct back slightly. Leave the tape in place on the exhaust duct, you only need to expose the joint to free the fan.
    • Peel the black tape connecting the fan to the exhaust duct back slightly.

    • Leave the tape in place on the exhaust duct, you only need to expose the joint to free the fan.

  3. Remove three 12.4 mm T10 screws securing the fan to the rear case.
    • Remove three 12.4 mm T10 screws securing the fan to the rear case.

  4. Remove the fan from the iMac. Remove the fan from the iMac.
    • Remove the fan from the iMac.

Заключение

To reassemble your device, follow these instructions in reverse order.

Andrew Optimus Goldheart

Участник с: 17.10.2009

433 837 Репутация

Автор 411 руководств

Команда

iFixit Участник iFixit

Community

108 членов

Автор 9 943 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 0

За последние 30 дней: 0

За всё время: 155