Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Введение

prereq to disconnect the digitizer

Запчасти

Детали не указаны.

  1. Use the flat end of a spudger to lift the digitizer cable connector straight up off of its socket. Use the flat end of a spudger to lift the digitizer cable connector straight up off of its socket.
    • Use the flat end of a spudger to lift the digitizer cable connector straight up off of its socket.

  2. Slide the spudger under the battery side of the digitizer board to begin separating it from the rear case. Lift the digitizer board up to free the last of the adhesive. Lift the digitizer board up to free the last of the adhesive.
    • Slide the spudger under the battery side of the digitizer board to begin separating it from the rear case.

    • Lift the digitizer board up to free the last of the adhesive.

  3. Lift and remove the front panel from the iPad.
    • Lift and remove the front panel from the iPad.

Заключение

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Участник с: 18.10.2012

394 720 Репутация

Автор 545 руководств

Команда

iFixit Участник iFixit

Community

108 членов

Автор 10 005 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 1

За последние 30 дней: 2

За всё время: 25