Перейти к основному содержанию

Введение

Prerequisite to remove the speaker after the logic board.

Запчасти

No parts specified.

  1. Remove the following screws:
    • Remove the following screws:

    • One 2.9 mm Phillips #000 screw

    • One 1.5 mm Phillips #000 screw

    • One 3.6 mm Phillips #000 screw

  2. Use the flat end of a spudger to gently lift the speaker from the rear case. Do not attempt to pry the speaker entirely out of the case.
    • Use the flat end of a spudger to gently lift the speaker from the rear case.

    • Do not attempt to pry the speaker entirely out of the case.

  3. The speaker has a small peg that slides into a slot beneath the home button cable socket. Lift the speaker and pull it toward the side of the phone to free this peg from the Lightning connector assembly. Remove the speaker.
    • The speaker has a small peg that slides into a slot beneath the home button cable socket.

    • Lift the speaker and pull it toward the side of the phone to free this peg from the Lightning connector assembly.

    • Remove the speaker.

Заключение

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

Участник с: 18.10.2012

385 577 Репутация

Автор 544 руководств

Команда

iFixit Member of iFixit

Community

104 членов

Автор 9 257 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 1

За всё время: 594