Перейти к основному содержанию

Этот документ имеет более свежие изменения. Перейти к последней непроверенной версии.

iPod Touch 5th Generation Lightning Connector Assembly Replacement

Абсолютно необходимое руководство
Это руководство предназначено только для использования в качестве обязательного условия для других руководств. Оно не полностью само по себе.

Выберете то, что вам нужно

  1. iPod Touch 5th Generation Lightning Connector Assembly Replacement, Lightning Connector Assembly: шаг 1, изображение 1 из 1
    • Use the tip of a spudger to peel back a small piece of tape covering a screw on the left side of the headphone jack.

  2. iPod Touch 5th Generation Lightning Connector Assembly Replacement: шаг 2, изображение 1 из 1
    • Remove the following screws securing the headphone jack, Lightning connector, and speaker.

    • Three 2.6 mm #000 Phillips screws

    • Two 2.0 mm #000 Phillips screws

  3. iPod Touch 5th Generation Lightning Connector Assembly Replacement: шаг 3, изображение 1 из 1
    • Use the flat end of a spudger to pry the speaker up from the rear case.

    • Do not try to remove the speaker, as it is soldered to the Lightning connector assembly.

  4. iPod Touch 5th Generation Lightning Connector Assembly Replacement: шаг 4, изображение 1 из 2 iPod Touch 5th Generation Lightning Connector Assembly Replacement: шаг 4, изображение 2 из 2
    • Grasping the large ribbon cable, gently pull the Lightning connector assembly out of the bottom of the case.

Заключение

To reassemble your device, follow these instructions in reverse order.

Andrew Optimus Goldheart

Участник с: 10/17/09

502 275 Репутация

Автор 407 руководств

Команда

iFixit Участник iFixit

Staff

136 членов

Автор 16 558 руководств

0 Комментариев

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 0

За последние 30 дней: 0

За всё время: 225