Введение

This is an easy guide. It should only take a few minutes to complete. The only tool required is Phillips #1 Screwdriver.

Запчасти

Никакие детали не требуются.

Lay the Roomba upside down on a flat surface. The edge brush is located near the battery pack.
  • Lay the Roomba upside down on a flat surface.

  • The edge brush is located near the battery pack.

Добавить комментарий

Using the Phillips #1 Screwdriver, unscrew the 7.2 mm Phillips #1 screw while holding the edge brush in place.
  • Using the Phillips #1 Screwdriver, unscrew the 7.2 mm Phillips #1 screw while holding the edge brush in place.

Добавить комментарий

Grab the edge brush and lift it up to remove.
  • Grab the edge brush and lift it up to remove.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

Samantha Barrett

Участник с: 13.01.2014

501 Репутация

Автор 5 руководств

Команда

Cal Poly, Team 17-5, Forte Winter 2014 Member of Cal Poly, Team 17-5, Forte Winter 2014

CPSU-FORTE-W14S17G5

5 членов

Автор 6 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 3

За всё время: 308