Перейти к основному содержанию
Английский
Голландский
Шаг 13
As I mentioned in step 9, I was punished by the lack of threads in my new window regulator So I broke out my tap and die set, and checked the bolt thread pitch, which was metric M6 x 1.0 I didn't notice until I'd already slipped my new part into the door... I actually pulled it back out of the door to tap the four holes
Preparing new parts
  • As I mentioned in step 9, I was punished by the lack of threads in my new window regulator

  • So I broke out my tap and die set, and checked the bolt thread pitch, which was metric M6 x 1.0

  • I didn't notice until I'd already slipped my new part into the door... I actually pulled it back out of the door to tap the four holes

  • If your part also has a lack of threads in the holes, be sure to check it before you've put the clip through the pin, and reinstalled the track bolts etc

Вставьте перевод здесь

Вставьте перевод здесь

Вставьте перевод здесь

Вставьте перевод здесь

Ваш вклад лицензируется под свободной лицензией Creative Commons.