Перейти к основному содержанию

Примечание: Вы редактируете необходимое руководство. Любые внесённые вами изменения влияют на все 4 руководства, которые включают этот шаг.

Английский
Итальянский
Шаг 5
Next, remove the ten 5.92mm T5 torx screws located underneath the kickstand. Remove the seven 5.87mm T5 torx  screws located under the camera casing. There is a sticker covering the second screw from the left.
  • Next, remove the ten 5.92mm T5 torx screws located underneath the kickstand.

  • Remove the seven 5.87mm T5 torx screws located under the camera casing. There is a sticker covering the second screw from the left.

  • Disconnect the rear cover from the main shell of the system by loosening it with a spudger where the gaps exist.

  • There is an electrical ribbon connecting the rear cover to the motherboard. Do not pull apart the rear cover from the motherboard once you have loosened the rear cover from the main system.

  • Continue working your way around to each corner and loosen the snap-ons on each side until the rear cover comes off.

Ora svita le dieci viti Torx T5 da 5,92 mm posizionate sotto il cavalletto.

Svita le sette viti Torx T5 da 5,87 mm posizionate sotto il rivestimento della camera. C'è un'etichetta che copre la seconda vite da sinistra.

Separa la scocca posteriore dal telaio infilando uno spudger nella fessura tra i due.

C'è un cavo a nastro che collega la scocca alla scheda madre. Non rimuovere completamente la scocca dopo averla separata dal telaio.

Continua a far scorrere lo spudger attorno gli angoli e lungo i bordi per liberare i ganci che fissano la scocca al dispositivo.

Ваш вклад лицензируется под свободной лицензией Creative Commons.