Почините Свои Вещи Сообщество Магазин

Wie du den Klebstoff deines iPhone Rückglases ersetzt.

Примечание: Вы редактируете необходимое руководство. Любые внесённые вами изменения влияют на все 13 руководства, которые включают этот шаг.

Назад к руководству
Английский
Немецкий
Шаг 12
iPhone 16 Pro Max Back Glass Installation, Connect the battery: шаг 0, изображение 1 из 1
Connect the battery

  • Use your finger or a spudger to press and connect the battery press connector onto the logic board.

  • This is a good point to test your repair before sealing up your iPhone. Power on your iPhone and make sure it works as expected. Power it back down and continue reassembly.

  • If your iPhone doesn't turn on, connect it to a power source and try again.

  • If you've replaced the logic board and the screen fails to turn on, you'll need to follow the screen guide to manually connect the display connector.

Akku anschließen

Verwende das flache Ende deines Spudgers oder deine Finger, um den Akku wieder anzuschließen.

Hake die Abdeckung des Akkusteckers in die dafür vorgesehenen Stelle auf dem Logic Board ein.

Nimm deinen Tri-Point Y000 Schraubendreher, drehe die Schrauben ein und befestige die Abdeckung.

Schalte dein iPhone an und teste es um sicherzugehen, dass alles funktioniert, bevor du es weiter zusammenbaust. Schalte es danach wieder aus, bevor du diese Reparatur beendest.

[title] Connect the battery
-[* black] Use the flat end of your spudger or your finger to reconnect the battery.
-[* black] Hook the battery connector cover onto its slot on the logic board.
-[* black] Use your tri-point Y000 driver to install the screws and secure the cover.
-[* black] Power on your iPhone and test it to make sure everything works before sealing it up. Power it back down before finishing this repair.
+[* black] Use your finger or a spudger to press and connect the battery press connector onto the logic board.
+[* icon_note] ***This is a good point to test your repair before sealing up your iPhone. ***Power on your iPhone and make sure it works as expected. Power it back down and continue reassembly.
+ [* icon_note] If your iPhone doesn't turn on, connect it to a power source and try again.
+ [* icon_note] If you've replaced the logic board and the screen fails to turn on, you'll need to follow the [guide|178634|screen guide|new_window=true] to manually connect the display connector.

Ваш вклад лицензируется под свободной лицензией Creative Commons .