Перейти к основному содержанию

Fix Your Stuff

Right to Repair

Parts & Tools

Notice: You are editing a prerequisite guide. Any changes you make will affect all 8 guides that include this step.

Английский
Немецкий
Шаг 24
As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case. Carefully insert an opening pick under the logic board, between the front-facing camera and the battery. Slide the pick toward the front-facing camera connector, and stop at the bend in the logic board.
  • As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to see if the adhesive is softened. If not, reheat the iOpener and reapply it to the back of the rear case.

  • Carefully insert an opening pick under the logic board, between the front-facing camera and the battery.

  • Slide the pick toward the front-facing camera connector, and stop at the bend in the logic board.

Wenn du bei den nächsten Schritten die Klebeverbindungen des Logic Boards ablöst, musst du immer erst vorsichtig prüfen ob der Kleber weich geworden ist. Wenn nicht, musst du den iOpener wieder erwärmen und erneut auf der Rückseite des iPad auflegen.

Setze sorgfältig ein Plektrum unter das Logic Board zwischen Frontkamera und Akku.

Schiebe das Plektrum in Richtung Frontkameraverbinder, und halte an der Biegung im Logic Board an.

Ваш вклад лицензируется под свободной лицензией Creative Commons.