Перейти к основному содержанию
Английский
Испанский
Шаг 4
Using wire strippers, strip a half an inch to three quarters of an inch of insulation off of each wire. After you strip the insulation off of the wires, twist the end of the wire in between your fingers so that the strands don't fray apart.
  • Using wire strippers, strip a half an inch to three quarters of an inch of insulation off of each wire.

  • After you strip the insulation off of the wires, twist the end of the wire in between your fingers so that the strands don't fray apart.

  • The amount of insulation you take off of each side doesn't have to exactly equal, but try to make it as close as possible.

Usando un pelacables, pela el aislante de cada cable del interior entre un centímetro y medio y dos.

Tras retirar el aislante, retuerce la punta del cable entre tus dedos para que las hebras de cobre no se deshilachen.

La cantidad de aislante que quites de cada lado no tiene por qué ser exactamente igual, pero intenta que lo sea lo más posible.

Ваш вклад лицензируется под свободной лицензией Creative Commons.